Triplett LAN testing products

WireMaster XR Lan Cable Test Set With Tracer Tone --

• Verifies point-to-point wiring of twisted pair LAN cables, telephone cables, and other types of cables that use RJ-45 and RJ-11 connectors
•   New "Local Mode" allows for testing of patch cables
•   Checks "straight-through", "reverse wired", and "crossover" LAN patch cables
•   Checks continuity in cable conductors
•   Generates 2 distinct warble tones usable for cable tracing
•   8 LED's identify the source and destination of each conductor
•   Direct connection of 6 pin RJ-11 or 8-pin RJ-45 cables
•   Allows remote testing of long cable runs up to 1000 feet
•   User selectable features:
• RJ-11 4 conductor or 6 conductor test
• Forward or Reverse sequencing on Transmitter
• High or Low Pitch Tracer Tone 
• Fast or Slow LED sequencing
• Local or Remote Test Mode on Receiver
•   TELCO Protected
•   Long Battery Life
•   Carrying Case Included
•   One Year Warranty 

LAN Fox

LAN Fox & Hound Set

LAN Fox & Hound 2 Set

LAN Fox & Hound Kit

LAN Fox & Hound 2 Kit

The LAN Fox is a compact, hand-held instrument designed to generate tracer tones for locating un-energized LAN cables. When used with an inductive amplifier, such as the Triplett Hound or Hound 2 Probe, cable tracing is made quickly and easily. The single selector switch sets the tone of the Lan Fox to HI or LO warble, while the LED gives a visual indication that the unit is on.

• Generates 2 distinct tones usable for LAN cable tracing 
•  Direct connection of standard RJ-45 modular plugs 
•  RJ-45 to BNC adaptor allows for tracing of BNC cables 
•  One Year Warranty 

LAN Cable Modular Adaptor Box --

The LAN Cable Modular Adaptor Box is a compact, hand-held instrument that can couple between different formats of LAN wiring. Tip/Ring of Pair 1 on any jack are directly connected to Tip/Ring on all other jacks. Pairs 2 through Pairs 4 are connected similarly. In some cases, more than one LAN Cable Modular Adaptor Box may be required.

• Allows coupling between any two of eight popular LAN wiring formats 
•  No battery required 
•  One year warranty 

Hound 2

Fox and Hound 2 Set

Fox and Hound 2 Kit

The streamlined HOUND 2 Probe inductive tracer has all of the features of the original Hound plus a few extra. Its sleek case design allows for better access in those tight, hard-to-reach areas. The HOUND 2 also has an adjustable volume control and an LED that intensifies as the tone signal gets stronger. This makes wire identification easier in noisy environments where the speaker cannot be heard.

• Streamlined case design
•  Adjustable volume control
•  LED which light intensifies as the signal gets stronger
•  Contains a hi-gain, hi-impedance amplifier
•  Capable of identifying the Fox's tone up to 12 inches away
•  Rugged, moisture resistant, mylar cone speaker
•  Convenient operation from a standard 9V battery
•  One Year Warranty

PairMaster LAN Cable Test Set --

The PairMaster gives its user the ability to verify and test basic LAN cabling installations. This unique LAN Cable tester can identify one of up to 16 cables with the simply press of a button. The PairMaster will also check for 8 faults including Near End Crosstalk (NEXT) for double split pairs:  Overvoltage   Open Pair   Shorted Pair   Crossed Pair  Split Pair  Reversed Pair  Transposed Pair  Double Split Pair The PairMaster, Includes: Remote Identifiers #1 and #2, (1) RJ-45 Patch Cable, (2) - RJ-45 In-Line couplers , (1) - 9 Volt Battery, Instruction Manual.  $396.00  The PairMaster Kit, Includes: All 16 Remote Identifiers, (1) RJ-45 Patch Cable, (2) - RJ-45 In-Line couplers , (1) - 9 Volt Battery, and Instruction Manual conveniently stored in a hard-sided carrying case.  $839.00

•  EIA/TIA 568 configuration for UTP Ethernet and Token Ring LAN Cables
•  Identifies 1 of 16 un-energized cables with the press of a button
•  Test 1/2, 3/6, 4/5, 7/8 Cable Pairs
•  Detects 8 Faults including Near End Crosstalk (NEXT) for Double Split pairs
•  2-seven segment LEDs display Fault Codes and Remote ID numbers
•  Overvoltage Indication on PairMaster and Remote Identifiers
•  2 Year Warranty on PairMaster
•  1 Year Warranty on Remote Identifiers
•  Low Battery Indication
•  4 PASS LEDs (Green)
•  4 FAIL LEDs (Red)

  Wire-Mapping The PairMaster will check the point to point wiring, commonly referred to as wire-mapping. This tells the user whether or not the cable pairs, 1/2, 3/6, 4/5, 7/8, are wired correctly at both ends. Green LEDs indicate Pass, Red LEDs indicate Fail. If a fault is detected, the corresponding Fault Code is displayed on the large, two digit, seven segment LEDs.

  Near End Crosstalk The Near End Crosstalk feature checks for excessive AC coupling between each pair in a cable. Once again, if a fault is detected, the PairMaster will display the Fault Code.

  Cable Identification The PairMaster can also identify a LAN Cable within a bundle. By connecting up to 16 available Remote Identifiers to the workstation wall jacks, the PairMaster will identify and display the number of the Remote Identifier connected to the cable. The user can then easily document the network topology.

  Overload Protection The PairMaster has built-in Overvoltage Protection. When voltage from a Central Office Battery is detected, the unit will flash (OL) and shut itself down.

  Remote Identifier The Remote Identifier is a small unit used in conjunction with the Triplett PairMaster for LAN Cable identification. The Remote Identifier properly terminates the LAN Cable when connected to the workstation wall jacks. It contains the necessary circuitry to allow the PairMaster to verify proper wiring within the cable. Each of the 16 Remote Identifiers has an overvoltaged LED which lights to indicate the presence of damaging voltage.    

---

WireMaster BNC --

The WireMaster BNC is a compact, hand-held instrument designed to quickly verify the continuity of un-energized coaxial patch cables terminated with BNC connectors.    NOTE: This LAN tester is not intended for use on powered cables. All cables must be non-powered, non-grounded and non-connected. Cable shown is not included with unit.

• Verifies continuity of coaxial cables with BNC connectors 
•  Checks for Open Conductor, Open Shield or Shorts 
•  4 LEDs indicate test results 
•  One Year Warranty 

---

WireMaster RJ-45 --

The WireMaster RJ-45 is a compact, hand-held instrument designed to quickly verify the wiring of un-energized, 8 conductor patch cables terminated with RJ-45 connectors. The 8 LEDs flash in sequence if the cable is wired correctly.    NOTE: This LAN tester is not intended for use on powered cables. All cables must be non-powered, non-grounded and non-connected. Patch cable shown is not included with unit.

• Verifies point-to-point wiring of RJ-45 patch cables 
• 8 LEDs identify the destination of each conductor in cable 
• Checks for continuity in straight-through wiring 
• One Year Warranty