Digital Test Gauges
Digital Test Gauges
... are rugged. The display is protected by a hard
poly-carbonate lens, circuitry is mounted in elastomer (for shock
resistance) and the case and sensor are stainless steel providing
corrosion resistance and an excellent barrier to emissions from cell
phones, two-way radios and other electrically noisy equipment.
The case is gasketed and water resistant per NEMA4
and IP66. A replaceable filter in the sensor
keeps out debris. Unlike mechanical pressure gauges, XP2i's
have the ability to survive being dropped and subjected to large
over-pressure events with no change in calibration.
XP2i Digital Pressure Gauges are
very easy to use. So simple to
use it doesn’t need or use configuration menus - just buttons. XP2i's
can be calibrated via the keypad or the RS232 port. The display
backlight is one of the best available on this type of pressure
accurate. XP2i's are rated in percent of reading
- like deadweight testers - but unlike deadweight testers, they’re not
affected by ambient temperature (or local gravity). XP2i's
are fully temperature compensated, so the accuracy is the same over the
entire operating temperature range, and they can be used to measure
5 Full (seven segment) digits
Internal resolution always
exceeds displayed resolution
Display rate: 3 readings per
Numeral Display height: 16.5mm
(0.65”) single line display14 mm (0.55”) for main numerals of dual line
Operating & Compensated:
-10°C to 50°C(14°F to 122°F)
Storage: -20°C to 70°C
(-4°F to 158°F)
Pressure Connection: ¼”
Electrical Connection: DB9,
RS-232 (environmentally sealed)
Liquids and gases compatible
with 316 stainless steel
Available certified for oxygen
Battery: Three size AA (RS6)
Battery Life: 1500 hours
typical (alkaline battery)
Low Battery Indicator:
Displayed battery icon
Description: 300 series SS
sealed to NEMA4/IP66Weight: 500g (17.6 oz.), including batteries
Exia Intrisically Safe, Class
I, Division 1,
Groups A, B, C & D,
Temperature code T4
Dual Line Display: Peak
pressure readings are displayed on a second linePanel Mounting: Add
option F4 for panel mounting (the XP2i fits in a 4½” gauge
cutout). XP2is with the F4 option can also be adapted to fit into 6” or
8½” gauge cutouts - see accessories section on next page.
AC Adapter Kit: P/N 2984 permits
operation of the XP2i from an AC supply of 90 - 264 VAC and 47 - 63Hz.
Carrying Case: P/N 3009, 35.6 cm (14”) L x 27.9 cm (11”) W x 8.3
cm (3¼″) H with egg-shell foam interior.
Gauge Adapter Kit: P/N 2955, adapts the 4 ½” Panel Mount
(F4 option) to fit into a 6” gauge cutout.
Gauge Adapter Kit: P/N 2956, adapts the 4 ½” Panel Mount
(F4 option) to fit into an 8½” gauge cutout.
WinXP2: XP2 Config Software.
Disable unwanted pressure units, set default pressure, water density,